IC MCT2E DATASHEET PDF

  • No Comments

MCT2 and MCT2E are also available in white package by . MCT2E. MCT2E-M. MCT V. (IC = 16 mA, IF = 32 mA, TA = °C). Details, datasheet, quote on part number: MCT2E Collector-emitter saturation voltage Input-to-output internal resistance TEST CONDITIONS = 10 µA, IC =1. MCT2E ON Semiconductor / Fairchild Transistor Output Optocouplers DIP-6 PHOTO TRANS datasheet, inventory & pricing.

Author: Dami Mezilrajas
Country: Cameroon
Language: English (Spanish)
Genre: Marketing
Published (Last): 27 November 2009
Pages: 132
PDF File Size: 11.94 Mb
ePub File Size: 1.81 Mb
ISBN: 980-8-54574-969-6
Downloads: 13357
Price: Free* [*Free Regsitration Required]
Uploader: Tehn

The digital signal given to the IR LED will be reflected on the transistor but there will be no hard electrical connection between the two. Submitted by admin on 7 March This is mct2f the isolation occurs.

In the Photo-transistor mode we will not be using the base pin pin 6 of the transistor; we just have to connect the anode pin of the IR LED pin 1 to the logic input which has to be isolated and the cathode pin 2 of the IR led to the ground.

This way the logic input will be reflected at the logic output and still provides and isolation between the two.

  CEAG GHG 791 PDF

MCT2E Datasheet(PDF) – TI store

TL — Programmable Reference Voltage. It is normally not used for transistor mode, but will be used in diode mode. Then Pull high the collector pin of the transistor using a resistor here I have used 1K and connect the collector pin to the output of your desired logic circuit.

The Emitter pin 4 is grounded. There pull-up resistor 1K acts as a load resistor. The complete working can also be understood form the GIF file above.

IC MCT2E Optocouplers

Connected to isolated ground. This will short the collector and emitter and hence the Logic Output voltage will become zero. This is the logic output pin 6 Base B Base pin of the Transistor.

Base pin of the Transistor. The below waveform shows the time taken for the output to transit from one state to another. The ground line of the IR LED pin 2 and the ground line of the transistor pin 4 will not be connected together.

More details can be found at the MCT2E datasheet which is available for download at the end of this page. But uc the Logic input is made high, this high voltage should be a minimum of 1.

  A CAMPANHA DO ARGUS PDF

This comes in very adtasheet when you are trying to isolate a noisy signal from your digital electronics, so if you are looking for an IC to provide optical isolation in your circuit design then this IC might be the right choice for you. Out of which the Phototransistor mode is mostly used, so let us look at that mode first.

Another important parameter to consider while using an Optocoupler, is the rise time tr and fall time tf. The output will not get high as soon as the input logic is made low and vice versa.

This IC is used to provide electrical isolation between two circuits, one part of the circuit is connected to the Mct2f LED and the other to Photo-transistor. When the IR led is powered the light from it falls on the transistor and it conducts.